LAN9303 LINUX DRIVER

Registered udp transport module. End of basic transceiver information. In reply to Schuyler Patton:. There is a lot of detail on eeprom management in the datasheet, so the LAN knows if it is blank first at first boot, etc. Vendor ID is When nRST negates those strapping pins are sampled.

Uploader: Mekazahn
Date Added: 7 July 2013
File Size: 50.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20258
Price: Free* [*Free Regsitration Required]

This thread has been locked. The console log is showing that board has 19 PHYs on it? The output of ethtool link is detected:. You have link beat, and everything is working OK. I can’t reveal the schematic, but I’ve read the LAN Ethernet Schematic Checklist, la9n303 it looks like the board designer also read it too, because everything is absolutely by the book.

Basic mode control register 0x Block Diagram would really help understand the set up.

When nRST negates those strapping pins are sampled. Able to perform Auto-negotiation, negotiation complete. A few things to check might be to verify with the vendor that the driver selected works with the switch.

  DELL PV100T DAT72 DRIVER DOWNLOAD

In reply to Schuyler Patton:. All postings and use of the content on this site are subject to the Terms of Use of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms of Use of this site. Trademarks Privacy Policy Terms of Use. linu

net: dsa: add SMSC/Microchip LAN three port ethernet switch driver []

I tried to check every single bit in every register of the smsc chip both in u-boot and in Linux and they match, so there must be something else. Yes Link partner advertised link modes: ALE Table size [ And I had someone disassemble the rather tightly packaged unit and verify that the strapping options were stuffed as in the schematic.

They will respond here. Chapter 8 of the LAN datasheet has the details. Error writing to cec: In reply to Schuyler Patton: We are glad that we were able to resolve this issue, and will now proceed to close this thread.

  HOW TO SET THE WEIGHTS TO THE TAYLORMADE R7 DRIVER DOWNLOAD

Linux/AM3359: SMSC LAN9303 problem

Mentions Tags More Cancel. Assuming the slave address in the control byte matches this address, the control byte is acknowledged by the device. Found an INTC at 0xfa revision 5. Symmetric Receive-only Supports auto-negotiation: Oct 24, 7: Lsn9303 need 25Mhz Clock running for the part to function.

The output of ethtool link is detected: The software team have been notified. Here is the full kernel start log: I’m using lonux SMSC driver version 1.

net: dsa: add SMSC/Microchip LAN9303 three port ethernet switch driver

Voltage driver support not added [ 1. OHCI generic platform driver [ 1. No specific information is known about this transceiver type.