Solved Go to solution. If your drive is not supported by Sun, check the drive manufacturer’s documentation or web site for their recommended configuration strings. I looked through my notes and saw that I used this command to dump the files: Configure SAN client on Solaris. This makes the tape engine very complex and unwiedly to support, and thus more prone to failures. In nbftclnt logs I can see this line: I would put it here:

Uploader: Gagami
Date Added: 5 August 2009
File Size: 52.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 62941
Price: Free* [*Free Regsitration Required]

All the services are up, both in the FT media and in the SanClient. Use is subject to license terms. I looked through my notes and saw that I used this command to dump the files: Hello all, I’m trying to configure SanClients in a test environment before doing it so in a production environment.

[ARSCLIST] DDS drive for AUDIO DAT (was 12 bit non-linear DAT and Sony LP mode

I can’t get the San Client to see any FT devices. Archive Python Xxx Scsi Sequential Device driver direct download was reported as adequate by a large percentage of our reporters, so it should be good to download and install.

UltraBac software used to publish a list of tape drives that had been tested with our software, or that “should” work with our software. This makes the tape engine very complex and unwiedly to support, and thus more prone to failures. The problem comes when I have to do step 4: Density code 0x24 DDS Having the ability for a fix to be enacted in the driver -or- the application is a very significant and strategic advantage to programs that utilize the Windows Tape APIs.


Another thing, some place in the guide, it says to run the following command to enable Client FT service, and I am confused because later in the same guide is tells to run the same command to disable client FT service. Other products, such as ArcServe for example were ported from other platforms like Unix or NetWare where no abstration layer was available.

The last entry ends with a semicolon.

If I can see your st. The data on the tapes I have is not of any value so I pythpn afford to experiment.

Solved: Configure SAN client on Solaris – VOX

Can anyone confirm this please: By the way, I ended up on the IBM site yesterday, there’s quite a lot of info for the drive including a Windows driver. UltraBac v5 for example circa is perfectly capable of utilizing a brand-new LTO3 tape drive without any modification whatsoever. Just add the entries manually: Installation Manager Success Stats: Any help with the configuration settings for this device and the software I can use to drive it will be greatly appreciated.


The following is an example of afchive line: We gave up trying to maintain this list of tape drives archife ago, and have not looked back since. Applications using SPTI must deal with all of this knowledge about all the different tape devices by maintaining a massive database inside its engine to be able adchive handle correctly each and every tape drive model on the market.

Select Your Operating System, download zipped files, and then proceed to manually install them. So, the way I read it, you either need to create or edit st. arcihve

Risk Mitigation and Compliance. Not sure which version of. Once final thing I tried from a web-post was: Configure SAN client on Solaris. Once again, thanks for the help, Tony. Re-discovered Tar and mt.

Please register, and get one. There were some significant performance and compatibility problems with using SPTI early on in NT’s development cycle, but these by-and-large have been addressed with 0416 release of Windows and later.