34980A IVI DRIVER DOWNLOAD

In which document can i read that the DMM automatically connects to the abus? Both methods of communication should not be used at the sametime with a device. Does empty channel list in configure “” mean DMM selected? Not sure what file it is looking for. You can download the latest version from:

Uploader: Zuludal
Date Added: 10 August 2009
File Size: 20.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72575
Price: Free* [*Free Regsitration Required]

Answers Answers and Comments 6 People are following this question.

34980A Multifunction Switch/Measure Mainframe and Modules IVI and MATLAB Instrument Drivers

Now my question was if there is a specific ivi function in the a driver that is doing the same? I am trying to simulate Agilent’s A mux unit.

NET framework later, you can use the file: It would be great if I could emulate this unit though MAX and use the drivers to control this instrument. Message 2 of The following two lines of code show an example of how to use the IO property: Message 7 of Most Active Software Boards: NET Ivu itself is not required by this driver.

The cons are that the interface is usually not as simple and debugging can be more difficult. Here is 39480a I did after I installed the driver: Message 9 of Thanks for replying, PKI.

  62412 51 DRIVER

Does empty channel list in configure ivk mean DMM selected? To be explicit, these are the classes this driver supports: I hope that clears things up a little bit and helps you get started on your application.

IVI drivers to simulate instruments – A/A mux – Discussion Forums – National Instruments

If possible, could you please try it at your end and attach screenshots? Connections between ivo on different matrices within the same module or between channels on different modules require the use of one analog bus. OR if it is correct that i have to create this command manually.

If you use the version independent ProgId in CoCreateInstance, you will not need to modify and recompile your code.

Unknown Chnl or RCN. There are no public properties which can be set from the command line. I think i have to manually send “INSTrument: When I do this I don’t get any errors: Doing a side-by-side installation of the driver to use multiple versions of the driver is not supported. The simulation capabilities are designed primarily to support NI Switch Executive version 2.

  HITACHI CP-X400 DRIVER

Agilent | Agilent A IVI-COM and IVI-C Driver Read Me

These three strings are values of properties in the IIviIdentity interface. In which document can i read that the DMM automatically connects to the abus? Known Issues Sending commands directly to the instrument bypassing the driver via Direct IO using the System.

Which function of the a-ividriver connects the DMM to Abus?

Uninstall This driver can be uninstalled like any other software from the Control Panel using “Add or Remove Programs”. How to reset all positions? If you use the version dependent ProgId in CoCreateInstance, you will need to modify and recompile your code to use the new ProgID once you upgrade to the next version of the driver. This is because only matrix 2 in 2-wire mode or matrices 3 and 4 in 1-wire mode have access to the analog buses.